I was inspired to do a wash basin for my toilet for quite some time already. I made the side, a little bit of the top; various parts were lying in my workshop at various degree of completion. The kick in the butt came when my neighbor living on the floor below me complained that my toilet floor was leaking. I needed to hack previous sink for the renovation.I can’t be living without a sink in the toilet, so I had to get my act together to finish this piece of art.
This piece is made of Burmese teak, which I read is used to make boats. The cabinet and doors are frame and panel construction. The joints are glued with titebond 3 and held with screws which are then covered by Ebony square pegs. Ebony square pegs are a hallmark of Green and Greene furniture design. The sink is actually a square box with proud finger joints. The sink sits on a flat top with breadboard end on one side to keep everything flat, Because of the urgency that I needed this piece of furniture, I did not do any cloud lift. The entire piece is finished with 3 layers of epoxy.